Category

Support

Fail Prints, why and what to do?

By | Support, Tutorials | No Comments

Although the handling of a 3d printer in general lines is simple, often the stress caused by the immediacy of a requirement, the lack of maintenance of the machine or even the lack of training of the operator can cause failures.
The most important thing in these cases is to carefully examine the failed print and try to find out what might have failed.
We have created a table to help you with identifying the causes of the failed print.

wdt_IDSymptomsCausesFixes
1• Supports were printed total or partially. • The part was pulled from the supports. • There are solid remains stuck on the bottom of the tank.INCORRECT STL PREPARATION • Support tips not strong enough. • Not enough support density.1. Clean the tank and filter the resin. 2. Use a stronger supports, increase the radius of the tip support and reinforce the lowest area of the part adding manually some more supports.
2• Nothing stuck on the platform and there are solid remains stuck on the bottom of the tank • The base of the supports or part is partially detached from side of the platform • Supports broken but NOT in the tip but in the post.Levelling problems, the platform isn't coplanar with the bottom of the tank at the begining of the print.1. Clean the tank and filter the resin. 2. Check that FEP film is correctly installed and touching the glass base all around. 3. Check that there are no cured resin stuck on the platform nor the bottom of the tank 4. Run a levelling wizard
3Model partially cured, some soft parts, print failed and there are solid remains stuck on the bottom of the tankWrong profile (not enough curing time)1. Check that you have used the right profile
4Model partially cured, some soft parts, print failed and there are solid remains stuck on the bottom of the tankLamp is near of its useful like (not enough lamp power) *Only in DentalFab1. Replace the lamp of the projector
5Model is oversizedWrong profile (too long curing time)1. Check that you have used the right profile
6The model was printed but the height on the Z axis is much larger or shorterIncorrect SLC file generation1. Check that the layer height used for the SLC file generation are equal to the profile layer height
7Nothing stuck on the platform nor the bottom of the tank• DLP Light Engine failed • Lamp/LED failure1. Contact your distributor
8Holes or Fractures• Mesh issues • Orientation issues • Dust, fingerprints, resin leak or dirt in the light path• Repair mesh • Change orientation, here are some clues: https://microlay.com/2018/07/10/playlist-mastering-print-studio-for-microlay-versus/ • Clean mirror (in case of the DentalFab), glasses and replace FEP film
9Rashing and Ragging• Dust, fingerprints, resin leak or dirt in the light path• Clean mirror (in case of the DentalFab), glasses and replace FEP film
10ShiftingModel prints with the layers appearing to shift back and forth, loose• Check to see if your build platform is loose • Increase the supports post radius